Dell Networking S6000 Uživatelský manuál stáhnout pdf (Strana 930)

100

101

CAUTION: Increasing the advertisement interval increases the VRRP Master dead interval,

resulting in an increased failover time for Master/Backup election. Take caution when increasing

the advertisement interval, as the increased dead interval may cause packets to be dropped

during that switch-over time.

VRRP Configuration

By default, VRRP is not configured.

Configuration Task List

The following list specifies the configuration tasks for VRRP.

• Creating a Virtual Router (mandatory)

• Configuring the VRRP Version for an IPv4 Group (optional)

• Assign Virtual IP Addresses mandatory)

• Setting VRRP Group (Virtual Router) Priority (optional)

• Configuring VRRP Authentication (optional)

• Disabling Preempt (optional)

• Changing the Advertisement Interval (optional)

• Track an Interface or Object

• Setting VRRP Initialization Delay

For a complete listing of all commands related to VRRP, refer to Dell Networking OS Command Line

Reference Guide.

Creating a Virtual Router

To enable VRRP, create a virtual router. In Dell Networking Operating System (OS), the virtual router

identifier (VRID) identifies a VRRP group.

To enable or delete a virtual router, use the following commands.

• Create a virtual router for that interface with a VRID.

INTERFACE mode

vrrp-group vrid

The VRID range is from 1 to 255.

NOTE: The interface must already have a primary IP address defined and be enabled, as shown

in the second example.

• Delete a VRRP group.

INTERFACE mode

no vrrp-group vrid

930

Virtual Router Redundancy Protocol (VRRP)

1 2 ... 925 926 927 928 929 930 931 932 933 934 935 ... 985 986

Komentáře k této Příručce

Žádné komentáře

Dell Networking S6000 Uživatelský manuál Strana 930

Komentáře k této Příručce

Související produkty a manuály pro Software Dell Networking S6000