Dell Networking S6000 Uživatelský manuál stáhnout pdf (Strana 955)

100

101

Configuring 104 10GbE Ports on the S6000 Platform

The capability to configure up to 104 10-Gigabit Ethernet ports is supported on the S6000 platform.

Starting with Dell Networking OS version 9.4(0.0), you can configure a maximum of 104 10G ports on an

S6000 switch.

The network processing unit (NPU) in an S6000 Switch contains two port pipes X and Y, with each pipe

supporting a maximum of 52 ports. Therefore, S6000 can support a maximum of 104 ports .

X pipe port mapping: from 0 – 60

Y pipe port mapping: from 64 - 124

When you configure twenty–six 40G ports for Fanout mode, a total of 104 10G ports is available. Because

this number is the maximum limit supported on the device, the remaining six 40G ports are disabled.

Configuring Fanout Mode

Keep the following in mind when you specify fanout on S6000 switch ports:

• When you configure the fanout feature, if the maximum limitation of port pipes (52 ports) is reached,

the remaining active 40G ports in the port pipe are disabled. In this case, the CLI displays a warning

message before the ports are disabled.

• Disabled ports are not available for configuration, are not displayed in the show command output, and

are not available for SNMP settings. When you reach the maximum limitation of port pipes, a warning

message displays.

• The following table describes the fanout feature on ports and the number of available ports per port

pipe:

Table 75. Fanout feature on ports

Configuration Available Ports (Per Pipe)

Each port Pipe: Any 12 Ports fanout. 12 ports fanout (4 * 10G) & 4 40G only ports

Each port Pipe: Any 13 Ports fanout. 13 ports fanout (4 * 10G) & 3 ports disabled

• If you configure 12 ports as fanout in each pipe, the system determines the ports that are not defined

for fanout and configures them as 40G ports. Entries in the port table are revised accordingly. If you

configure 13 ports as fanout in each pipe, the system identifies the three ports in each pipe that are

not configured in Fanout mode and deletes those entries from the port table. This removal of entries

ensures that ports are not created for such pipes.

• Entity MIB that uses static port configuration supports all of the ports, including those ports that are

configured for fanout.

• When you configure 26 ports as fanout, six ports are disabled. For disabled ports, interfaces are not

created.

• When you insert an optic into one of the disabled ports, a system logging message generates

indicating that a 40GE QSFP optic has been inserted into a disabled port.

S-Series Debugging and Diagnostics

955

1 2 ... 950 951 952 953 954 955 956 957 958 959 960 ... 985 986

Komentáře k této Příručce

Žádné komentáře

Dell Networking S6000 Uživatelský manuál Strana 955

Komentáře k této Příručce

Související produkty a manuály pro Software Dell Networking S6000