Dell Networking S6000 Uživatelský manuál stáhnout pdf (Strana 72)

100

101

Example of Locking CONFIGURATION Mode for Single-User Access

Dell(conf)#configuration mode exclusive auto

BATMAN(conf)#exit

3d23h35m: %RPM0-P:CP %SYS-5-CONFIG_I: Configured from console by console

Dell#config

! Locks configuration mode exclusively.

Dell(conf)#

If another user attempts to enter CONFIGURATION mode while a lock is in place, the following appears

on their terminal (message 1): % Error: User "" on line console0 is in exclusive

configuration mode.

If any user is already in CONFIGURATION mode when while a lock is in place, the following appears on

their terminal (message 2): % Error: Can't lock configuration mode exclusively since

the following users are currently configuring the system: User "admin" on line

vty1 ( 10.1.1.1 )

NOTE: The CONFIGURATION mode lock corresponds to a VTY session, not a user. Therefore, if you

configure a lock and then exit CONFIGURATION mode, and another user enters CONFIGURATION

mode, when you attempt to re-enter CONFIGURATION mode, you are denied access even though

you are the one that configured the lock.

NOTE: If your session times out and you return to EXEC mode, the CONFIGURATION mode lock is

unconfigured.

Restoring the Factory Default Settings

Restoring the factory-default settings deletes the existing NVRAM settings, startup configuration, and all

configured settings such as, stacking or fanout.

S6000MXL Switch

To restore the factory default settings, use the restore factory-defaults stack-unit {0-5 |

all} {clear-all | nvram}

command in EXEC Privilege mode.

CAUTION: There is no undo for this command.

Important Points to Remember

• When you restore all the units in a stack, these units are placed in standalone mode.

• When you restore a single unit in a stack, only that unit is placed in standalone mode. No other units

in the stack are affected.

• When you restore the units in standalone mode, the units remain in standalone mode after the

restoration.

• After the restore is complete, the units power cycle immediately.

The following example illustrates the restore factory-defaults command to restore the factory default

settings.

Dell#restore factory-defaults stack-unit 0 nvram

***********************************************************************

* Warning - Restoring factory defaults will delete the existing *

Management

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 985 986

Komentáře k této Příručce

Žádné komentáře

Dell Networking S6000 Uživatelský manuál Strana 72

Komentáře k této Příručce

Související produkty a manuály pro Software Dell Networking S6000